Skip to content
DraperyFlow

Blog

Living room color trends and how to hang curtains

· DraperyFlow

Color and hang are the two decisions a living room cannot hide. A good cloth on a rod bolted to the window trim still looks like a ready-made. A perfect mount in a color that fights the walls looks like a leftover from the last renovation. Spec both on the same treatment: the mill colorway and the hardware height, width, and return.

Color that is holding, not a one-season print

Cool gray as the default living-room drape is fading. What is replacing it is not a loud “color of the year” panel. It is warmer, quieter cloth that can sit next to oak, plaster, and mixed metals without reading as a sample-book leftover.

  • Warm plaster, oat, and putty — not stark white, not 2018 greige.
  • Olive, sage, and deep forest on a full-length pair, especially with wood tones.
  • Tobacco, camel, and oxblood as a contrast pair or a lined sheer layer, not as a printed novelty.
  • Ivory and natural linen still work; they need lining so they do not go dingy at the glass.

Pattern is smaller and more architectural: a tone-on-tone stripe, a quiet check, a woven texture. Large-scale botanicals still sell; they need a vertical repeat on the ticket and a stack that does not eat half the motif. If the client wants a trend color, put it in a pillow or a roman on a secondary window and keep the main pair in a cloth you can live with for ten years. Custom drapery is not a throw pillow.

Performance weaves belong in a real living room — pets, south glass, TV light. Specify them as the face, not as an apology. The workroom still needs width, repeat, and whether the goods railroad. “Performance” on the tag does not change the cut.

How to hang curtains so they look specified

Hang is not décor advice. It is finished width, finished length, and mount. Those three numbers are what the calculator, the work order, and the install sheet must share.

Height

Do not set the rod on the window trim. Take the heading toward the ceiling — or all the way to the ceiling on a track — so the glass reads taller and the stack sits in the wall, not on the mullion. A common outside-mount starting point is several inches above the frame; many living rooms look better with a ceiling or just-below-crown mount. Measure finished length from the hanging point you actually use (ring, hook, track carrier), not from a guess at the bracket.

Width

The rod or track should run past the frame so stacked panels clear the glass. How far depends on fullness and heading: a 2.5× pinch-pleat pair needs more stack-back than a flatter ripplefold. If the hardware stops at the casing, the cloth will cover glass even when “open.” That is a spec error, not a sewing error.

Return, overlap, and the hem at the floor

Returns wrap to the wall so you do not see the bracket and a stripe of light. Overlap is how a pair meets at center. Both add cloth after fullness; skipping them is how a pair looks skinny on a correct rod. At the floor, decide kiss, float, or a small break before you quote length. A fashion puddle is a client choice and a vacuuming problem. Most living rooms want a kiss or a half-inch break so the hem stays clean. The install sheet should say the mount height and the floor finish you measured to.

Hardware that matches the heading

Ripplefold belongs on a track with the right carrier spacing. Pinch pleat belongs on rings or a pin hook, at the density the heading was sewn for. Grommets need a rod diameter the eyelet can actually take. Do not hang a ripplefold heading on a decorative pole “because it looks nicer in the room.” The heading will not train, and the fullness you sold will not appear.

Motor is a living-room decision on wide spans and on glass that nobody will pull twice a day. Specify control side, power, and fabric weight before the workroom cuts. Motor does not change yardage; it changes the install sheet and the hardware line.

One spec, two documents

Color lives on the fabric line. Hang lives on finished size and mount. The client sees both on the quote. The table sees cloth and cuts, not the rod. The crew sees height, width, return, and floor. If those diverge, you will hang a correct pair at the wrong height and argue about “how curtains should look.” Put the colorway and the mount on the same treatment before anyone orders COM.

Try the full workroom for 14 days.

All-in-one workroom management software. Full Studio trial, no credit card. Keep Starter or Studio when you are ready.